Soundbarrier PCS-5000 Professional Amplifier
5 in stock
Rotary level control, one for each channel.
Unit is turned ON when button is pushed.
Flashes to show audio output in each channel
Red LED, one per channel illuminates when the channel’s output Signal reaches the onset of audible clipping.
Illuminated when Amplifier goes into self-protection against destructive phenomena
PARALLEL & BRIDGE MODE INDICATOR:
LED Illuminates when the amplifier is set to Bridge or Parallel mode
INPUT SENSITIVITY SWITCH:
Switch to adjust input sensitivity to 0.77V, 1.0V or 1.44V
Switch to activate input signal compressor
GROUND LIFT SWITCH:
Switch up to disconnect the chassis from ground if necessary to eliminate hum caused by ground loops
MODE SELECTOR SWITCH:
Three-positioned switch. “Stereo” operates the amplifier as two independent channels. “Bridged” bridges the two output channels for twice the output voltage. “Parallel” is used for two or more amplifiers operating in-phase into a common load.
XLR Active Balanced and ¼” TRS Balanced and Unbalanced per channel
High Current Binding Posts (Bridge Mode) and Speakon type connectors per channel
Resets Circuit Breaker that protects your power supply.
All PCS amplifiers are protected against Shorted, open or mismatched loads; overloaded power supplies; excessive temperature; Subsonic and Ultra Sonic phenomena; they also protect loudspeakers from input/output DC transients and Soft Starts.
Internal Heat Sinks and 2 variable two speed fans combine for rapid heat dissipation.
2Ω Dual (per channel): 2400W
4Ω Dual (per channel): 1900W
8Ω Dual (per channel): 1200W
4Ω (Bridge / Mono): 4400W
8Ω (Bridge / Mono): 3000W
Amplifier Type: Class H
Frequency Response: 15Hz-25kHz (+0/-1dB)
Total Harmonic Distortion (THD): <0.03%
Intermodulation Distortion (IMD): (60Hz & 7kHz @ 4:1); Less than 0.04%
Slew Rate (Input Filter Limited): 40V/us
Damping Factor: Greater than 400:1
Input Sensitivity: 0.77V – 1.0V – 1.44V Selectable
Input Impedance (Balanced): 10K Ohm Balanced to Ground
Power Supply: 110-120V 60Hz or 200-240V 50Hz
Dimensions: 482 x 383 x 132mm (Standard 19” Rackmount Width + 3U)
Net Weight: 73 lbs (33 kg)
|Dimensions||21 x 18 x 8 in|